Tyco T210+ Infrared Flame Detector Test Source For S200+ Detectors - 592.001.016
- Manufacturer : Tyco
- Part Code : T210+ / 592.001.016
- Infrared Flame Detector Test Source
- For S200+ Detectors
Tyco T210+ Infrared Flame Detector Test Source For S200+ Detectors
Tyco T210+ Infrared Flame Detector Test Source For S200+ Detectors - 592.001.016
The T210+ Test Source is used to test S200/ S200+ and FV400 Series of infra-red flame detectors in both safe and hazardous areas. The T210+ is ATEX/IECEx approved for use in zones 1 and 2 for group IIC gasses rated T1 - T4.
Approval for zone 0 is not available for this type of equipment, although it is understood that dispensation may be obtainable on a site-by-site basis from the Factory Inspectorate.
Description
The T210+ consists of a module mounted in a cradle which can be hand held or secured to an extendable pole. The module is self-aligning on the detector by means of an adaptor secured to the front of the cradle. The assembly is then held against the detector to check the response time and sensitivity of the detector.
The Test Source is enclosed in a glass filled polyester housing which is approved as an increased safety or ‘e’ housing. It contains a bulb which is electrically pulsed by an intrinsically safe circuit to simulate typical flame flicker. Infrared radiation from the lamp is focused by a parabolic reflector through a sapphire window onto
the detector.
The unit is powered by a Baseefa approved PP3 battery (see “Batteries”).
The T210+ is switched on with a rotary selector switch knob located on the rear of the unit.
